Cloud Sprinkler Installation

1. Tools and Materials Needed

• Drill and appropriate drill bits
• Screwdriver
• Wire stripper
• Waterproof sealant glue (if installing outside)
• Cloud Sprinkler™

2. Preparing for Installation

• Before beginning the installation, ensure you have all necessary tools and materials.
• Locate a suitable installation site near a power source and within reach of your irrigation system's wiring.
• Ensure the Cloud Sprinkler™ power adapter with a two-meter-long cable is available.

3. Mounting the Cloud Sprinkler™ Back Panel

• Hold the Cloud Sprinkler™ bottom panel against the wall where you want to mount it and mark the screw holes with a pencil.
• Drill pilot holes at the marked locations and insert wall anchors if necessary.
• Secure the Cloud Sprinkler™ bottom panel to the wall using the mounting screws.

4. Connecting the Wires

Follow the wiring diagram included with your Cloud Sprinkler™. Here are the general steps:

• Strip 1/2 inch of insulation from the ends of each wire.
• Connect the common wire from the valves to the common terminal on the Cloud Sprinkler™.
• Connect each valve wire to the corresponding zone terminal on the Cloud Sprinkler™.
• There is an option to connect two water meters: 'WM1' and the'COM' terminal or 'WM2' and the'COM' terminal. The rain switch connects to the 'Rain SW' terminal and the 'COM' terminal. All 'COM' terminals are internally connected.
• If using AgroGlide™ Two-Wire technology, connect the Two-Wire cable to the AG input terminal on the Cloud Sprinkler™ and COM terminal, then connect the sensors and valves along the Two-Wire path.
• Secure all Two-Wire connections with waterproof wire connectors.

5. Mounting the Cloud Sprinkler™ Front Panel

• Secure the Cloud Sprinkler™ front panel with a screwdriver.
• Make sure the top panel sealant is in the correct position for waterproofing.

6. Powering Up the Cloud Sprinkler™

• Connect the Cloud Sprinkler™ power adapter to a power source.
• Turn on the power.
• Check the Cloud Sprinkler™ display to ensure it is receiving power.

7. App Connectivity

• After power on Cloud Sprinkler™, install the AgroGlide™ app on your mobile device.
• Confirm the signup properly in the app, go to settings, and click the "Add Device" menu.
• Scan the device QR code with the app's camera (make sure to give the app camera permission).

  Note: To find the QR code, go to the Cloud Sprinkler™ LINK menu (SETTINGS > LINK) and press the 'Enter' button.

• Once the device type and ID are detected, give the device a name and set the correct location for weather data usage.
• Go back to the home menu, find the added device, and click the connect button.

  Any number of devices can be added to a single user account. All devices will be listed on the home screen for use.

8. Configuring the Cloud Sprinkler™

• Follow the Cloud Sprinkler™ user manual for more setup details.
• Program the watering schedule for each zone. Refer to the user manual for specific programming instructions.
• For Cloud Sprinkler™ with AgroGlide™ sensor inputs, configure the Intelligent Sensor Watering Technology to use the sensor data for scheduling.

9. Testing the System

• Manually activate each zone to ensure the valves open and close properly.
• Check for any leaks or wiring issues and address them as necessary.